Smittybilt D0989CC Nerf-Step Manuel d'utilisateur télécharger pdf

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Nerf Step (Part# D0989CC)

09-10 Dodge Crew Cab

Nerf-Step (Part# D0989QC)

09-10 Dodge Quad Cab

Hardware Kit Contains: Recommended Tools:

12) 3/8”x 1” hex bolts 9/16” Socket Wrench

12) 3/8” Flat Washers Drill- 1” hole saw

12) 3/8” Threaded Clips

Step 1: Locate the driver side nerf-step by matching the shorter tail bend to the front of the vehicle. NOTE:

Some models have a straight cut end with a cap, that end will face the rear tire.

Step 2: Starting with the driver’s side, locate the six factory mounting hex holes (which are positioned on the

vertical side of the floor pan below the doors) with two in the front, two in the middle, and two towards the

rear of the body.

Step 3: Mark and drill a pilot hole in the center between each factory hex head hole. Next, in each pilot hole,

drill a 1” hole using a 1” hole saw. Using the 3/8” threaded clips, slide two clips in each 1” hole outward, so

the threaded part is visible through the hex holes. SEE FIGURE 1.

Fig. 1

Step 4: Align the nerf-step up to the body where the three brackets on the nerf-step match up to the six

threaded locations. Next, start all six 3/8” x 1” hex bolts, flat washers and finger tighten.

Step 5: Starting with the front, push the nerf-step up and torque the front bolt to 15-20 ft/lbs, level the rear tail

section and then torque the very rear bolt. Finally, tighten all remaining bolts in between. Repeat on

passenger side.

This concludes the installation. Questions? Call 281-880-6322

1 2 3

For Technical Support/Warranty Information ple

Page 2

For Technical Support/Warranty Information ple

Page 3

For Technical Support/Warranty Information ple

Pas de commentaire

Smittybilt D0989CC Nerf-Step Manuel d'utilisateur