Smittybilt F99100CC Nerf-Step Manuel d'utilisateur télécharger pdf

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Compton, CA 90220

Installation Instructions

Nerf-Step

(Part # F989QC,F0996CC, F0486SC, F99100CC , )

09-10 Ford F150 Super Cab, Super Crew,04-08 F150 Super

Crew, 99

10 Super Duty Crew Cab

Parts Included Qty Tools Required

3/8” x 1 ½” Carriage Bolts 12

9/16 Wrench

3/8” Flat Washer 12 9/16” Socket with Ratchet

3/8” Lock Washer 12

STEP 1: Identify the driver and passenger side bars. (The short 45 degree bend at the end of each nerf-step

goes towards the front of the vehicle.)

STEP 2: Starting on the drivers’ side, first open the vehicle doors and then hold the nerf-step to the

underside of the vehicle. Line up the oval holes in the nerf-step bracket with the factory holes on the

bottom pinch weld of the vehicle. (On certain models you may need to drill a couple of 3/8” holes)

STEP 3: Using the included 3/8” hardware, insert a carriage bolt from the outside and attach with washer

and nut. Proceed to install remaining bolts. (Do not tighten completely at this time.) ( Fig A,B)

STEP 4: Hold the front of the nerf-step firmly against the body of the vehicle and tighten the front bolt

completely. Now move to the rear of the step and hold the step up against the body until it is level

with the side of the vehicle. When desired level is reached tighten the rear bolt completely. You

may now tighten the remaining bolts. Make sure all bolts are tight. Installation is now complete.

Follow same steps for opposite side.

NOTE: Carefully read entire instructions thoroughly before attempting to install this part.

It is recommended to have some additional help while installing these bars.

Picture is for sample use, may not be actual bars

1 2

WWW.SMITTYBILT.COM For Techni

Page 2

WWW.SMITTYBILT.COM For Techni

Pas de commentaire

Smittybilt F99100CC Nerf-Step Manuel d'utilisateur