Smittybilt 868069 Easy Install Billet Grille Manuel d'utilisateur télécharger pdf

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220

Installation Instructions

Easy Install Billet Grille (Part # 868075)

2001-2002 Chevy Silverado HD

NOTE: Carefully read entire instructions thoroughly before

attempting to install this part.

TOOLS REQUIRED

- Phillips Screw Driver

- 4mm wrench

INCLUDED COMPONENTS

1 – Billet Grille (top & bottom pieces)

8 – Metal Brackets

8 – M4 x 30mm Phillips Screws

8 – M4 Flange Nuts

Figure 1 – Included Hardware

INSTALLATION INSTRUCTIONS

1. Inspect product and check components with items listed above.

2. Pop Hood, remove plastic shroud at the top and set fasteners aside.

3. Optional: Using factory instructions, remove the entire front grille shell (as pictured in all figures).

4. Position lower section of the Billet Grille onto grille shell cavity (Figure 2).

Figure 2 – Front View of positioning Billet Grille

5. Loosely attach Billet Grille by holding Metal Bracket behind factory grille shell and inserting Phillips Screw (from

the front) through the Billet Grille hole and Metal Bracket, secure it with Flange Nut provided (Figure 3).

Figure 3 – Rear view of vehicle’s shell;

top and bottom Billet Grill attached with Metal Brackets and Flange Nuts

6. Repeat Steps 4 and 5 for the top section of the Billet Grille.

7. Once the Billet Grille is loosely attached, center it and tighten all Screws at the same rate.

8. Reinstall the plastic shroud with the fasteners removed in Step 2.

1 2

For Technical Support/Warranty Information pl

Page 2

For Technical Support/Warranty Information pl

Pas de commentaire

Smittybilt 868069 Easy Install Billet Grille Manuel d'utilisateur