Smittybilt 76641 Rock Crawler Side Armor/ Rocker Guards Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Smittybilt 76641 Rock Crawler Side Armor/ Rocker Guards. Smittybilt 76641 Rock Crawler Side Armor/ Rocker Guards User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Rock Crawler Side Armor/ Rocker Guards
1987-2006 Jeep Wranglers
Part # 76631,76641
NOTE: Carefully read entire instructions thoroughly before attempting
to assemble and/or install this product.
Smittybilt is in no way
responsible for any damage to the vehicle or personal injury that
may
occur during the installation or use of this product.
CAUTION: This
product is designed primarily to enhance the appearance of the vehicle.
Do NOT rely on it in any way to protect against injury or death in the
event of an accident. “ALWAYS WEAR YOUR SEAT BELT “
Parts Included Qty Tools Needed
Driver Side Guard 1
Ratchet and Socket Set
Passenger Side Guard 1
Drill
3/8” x 1” Self Tapping Bolts 16
Drill Bit Set
Step 1: Position the guard up to the frame. Maintain a ½” minimum gap between the bottom of the vehicle
and the top of the guard. Adjust the guard from front to back until it is parallel to the side of the
frame while also making sure it is parallel with the side of the vehicle. (Assistance is recommended
while installing these guards)
Step 2: When you are satisfied with the placement of the guard, mark the side of the frame through the
mounting holes located on the guards brackets. After you have marked all the holes place the
guard to the side. Center punch the frame at the marked locations and drill a 5/16” hole in the
frame. Caution: Before drilling be sure to check the backside for hazards or obstructions.
Step 3: Position the guard back against the frame and line up the holes in the brackets with the holes that you
just drilled on the frame. Secure the guard to the frame using the supplied self tapping bolts. Tighten
all bolts at this time. (Figure 1, 2)
Step 4: Repeat these steps to install the other side. Installation is now complete.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Installation Instructions

For Technical Support/Warranty Information pl

Page 2

For Technical Support/Warranty Information pl

Commentaires sur ces manuels

Pas de commentaire